FLAT 10, 835 ALTRINCHAM ROAD

Your options for this home

Based on this property's recorded characteristics, this 48m² 1950s flat has a current EPC rating of E40 and its recorded heating. HotAndCold estimates a space-heating requirement of approximately 3.0–4.0kW. This property's recorded energy efficiency is comparatively low. The estimated heat demand per square metre is towards the lower end.

Hot&Cold snapshot

What stands out about this home

How this home compares locally

Based on 60 EPC-recorded properties nearby.

Built form

Flat

Internal area (EPC)

48 m²

Building footprint

~595 m²

Approx. dimensions

~51.4 × 25.1 m

Main building axis

NE–SW

Estimated floors

2

Nearest building

1.8 m

Footprint & dimensions derived from Overture Maps building data (ODbL). Approximate, not survey-grade.

How this home is constructed & heated

Recorded on its Energy Performance Certificate.

Walls

Cavity wall, filled cavity

Roof

Flat, no insulation (assumed)

Windows

Single glazed

Main heating

Electric storage heaters

Heating controls

Manual charge control

Hot water

Electric immersion, off-peak

Floor

(other premises below)

Energy improvement potential

Recommended improvements for this property

Measures from this home’s official Energy Performance Certificate assessment that could raise its rating and cut running costs, specific to FLAT 10, 835 ALTRINCHAM ROAD, MANCHESTER, M23 9QQ.

1. 1
   Replace single glazed windows with low-E double glazingIndicative cost: £3,300 - £6,500

   Double glazing is the term given to a system where two panes of glass are made up into a sealed unit. Replacing existing single-glazed windows with double glazing will improve comfort in the home by reducing draughts and cold spots near windows. Double-glazed windows may also reduce noise, improve security and combat problems with condensation.

2. 2
   Fan assisted storage heaters and dual immersion cylinderIndicative cost: £600 - £800

   Modern storage heaters are smaller and easier to control than the older type in the property. Ask for a quotation for new, fan-assisted heaters with automatic charge control. A dual-immersion cylinder, which can be installed at the same time, will provide cheaper hot water than the system currently installed. As installations should be in accordance with the current regulations covering electrical wiring, only a qualified electrician should carry out the installation. It is best to obtain advice from a qualified heating engineer. Ask the engineer to explain the options, which might also include switching to other forms of electric heating.

3. 3
   Draught proof single-glazed windowsIndicative cost: £80 - £120

   Fitting draught proofing, strips of insulation around windows and doors, will improve the comfort in the home. A contractor can be employed but draught proofing can be installed by a competent DIY enthusiast.

4. 4
   Flat roof insulationIndicative cost: £850 - £1,500

   Insulation of a flat roof will significantly reduce heat loss through the roof; this will improve levels of comfort, reduce energy use and lower fuel bills. Where the weatherproof membrane is sound and the roof construction is appropriate, suitable insulation can be placed on top of the roof membrane (inverted roof). Alternatively, where the weatherproof membrane needs to be replaced insulation can be provided under the weatherproof membrane (warm roof). Further information about roof insulation and details of local contractors can be obtained from the National Insulation Association (www.nationalinsulationassociation.org.uk).

Source: the property’s domestic EPC recommendations (open data). Indicative only, get a professional survey before committing to any measure.

Energy rating history

Recorded change: +9 EPC points across 2 certificates.

1. 2014F31
2. 2014E40

Other homes nearby