FLAT 69, WORSLEY COURT

Your options for this home

Using the recorded floor area and EPC characteristics, this 46m² 1960s flat has a current EPC rating of D66 and mains-gas heating. HotAndCold estimates a space-heating requirement of approximately 2.5–3.5kW. The recorded EPC score places this home in the middle of the efficiency range. The estimated heat demand per square metre is towards the lower end.

Hot&Cold snapshot

What stands out about this home

How this home compares locally

Based on 48 EPC-recorded properties nearby.

Built form

Flat

Internal area (EPC)

46 m²

Building footprint

~772 m²

Approx. dimensions

~55.2 × 14.0 m

Main building axis

N–S

Estimated floors

6

Nearest building

15.4 m

Footprint & dimensions derived from Overture Maps building data (ODbL). Approximate, not survey-grade.

How this home is constructed & heated

Recorded on its Energy Performance Certificate.

Walls

System built, with external insulation

Roof

Flat, limited insulation (assumed)

Windows

Fully double glazed

Main heating

Community scheme

Heating controls

Flat rate charging, room thermostat only

Hot water

Community scheme

Floor

(another dwelling below)

Energy improvement potential

Recommended improvements for this property

Measures from this home’s official Energy Performance Certificate assessment that could raise its rating and cut running costs, specific to FLAT 69, WORSLEY COURT, WILMSLOW ROAD, MANCHESTER, M14 5LU.

1. 1
   Low energy lighting for all fixed outletsIndicative cost: £10

   Replacement of traditional light bulbs with energy saving recommended ones will reduce lighting costs over the lifetime of the bulb, and they last up to 12 times longer than ordinary light bulbs. Also consider selecting low energy light fittings when redecorating; contact the Lighting Association for your nearest stockist of Domestic Energy Efficient Lighting Scheme fittings.

2. 2
   Flat roof or sloping ceiling insulationIndicative cost: £850 - £1,500

   Insulation of a flat roof or sloping ceiling will significantly reduce heat loss through the roof; this will improve levels of comfort, reduce energy use and lower fuel bills. Where the weatherproof membrane is sound and the roof construction is appropriate, suitable insulation can be placed on top of the roof membrane (inverted roof). Alternatively, where the weatherproof membrane needs to be replaced insulation can be provided under the weatherproof membrane (warm roof). Further information about roof insulation and details of local contractors can be obtained from the National Insulation Association (www.nationalinsulationassociation.org.uk).

3. 3
   High performance external doorsIndicative cost: £1,000

   High performance external doors contain insulation and lose heat at about half the rate of conventional external doors.

4. 4
   Add additional 80 mm jacket to hot water cylinderIndicative cost: £15 - £30

   Increasing the thickness of existing insulation by adding an 80 mm cylinder jacket around the hot water cylinder will help maintain the water at the required temperature; this will reduce the amount of energy used and lower fuel bills. The jacket should be fitted over the top of the existing foam insulation and over any thermostat clamped to the cylinder. Hot water pipes from the hot water cylinder should also be insulated, using pre-formed pipe insulation of up to 50 mm thickness (or to suit the space available) for as far as they can be accessed to reduce losses in summer. All these materials can be purchased from DIY stores and installed by a competent DIY enthusiast.

Source: the property’s domestic EPC recommendations (open data). Indicative only — get a professional survey before committing to any measure.

Other homes nearby