12, PEACH BANK HOUSE

Your options for this home

HotAndCold's model combines the recorded floor area, property type and EPC data, so this 46m² 1990s flat has a current EPC rating of C72 and mains-gas heating. HotAndCold estimates a space-heating requirement of approximately 2.0–2.5kW. The recorded EPC score is comparatively high for existing housing stock. The estimated heat demand per square metre is towards the lower end.

Hot&Cold snapshot

What stands out about this home

How this home compares locally

Based on 18 EPC-recorded properties nearby.

Built form

Flat

Internal area (EPC)

46 m²

Building footprint

~712 m²

Approx. dimensions

~69.3 × 11.2 m

Main building axis

E–W

Estimated floors

2

Nearest building

2.1 m

Footprint & dimensions derived from Overture Maps building data (ODbL). Approximate, not survey-grade.

How this home is constructed & heated

Recorded on its Energy Performance Certificate.

Walls

Cavity wall, as built, insulated (assumed)

Roof

Pitched, 150 mm loft insulation

Windows

Fully double glazed

Main heating

Boiler and radiators, mains gas

Heating controls

No time or thermostatic control of room temperature

Hot water

From main system

Floor

(another dwelling below)

Energy improvement potential

Recommended improvements for this property

Measures from this home’s official Energy Performance Certificate assessment that could raise its rating and cut running costs, specific to 12, PEACH BANK HOUSE, PEACH BANK, MIDDLETON, MANCHESTER, M24 1BG.

1. 1
   Low energy lighting for all fixed outletsIndicative cost: £25

   Replacement of traditional light bulbs with energy saving recommended ones will reduce lighting costs over the lifetime of the bulb, and they last up to 12 times longer than ordinary light bulbs. Also consider selecting low energy light fittings when redecorating; contact the Lighting Association for your nearest stockist of Domestic Energy Efficient Lighting Scheme fittings.

2. 2
   Upgrade heating controlsIndicative cost: £450

   The heating system would benefit from a programmer and room thermostat to enable the boiler to switch off when no heat is required; this will reduce the amount of energy used and lower fuel bills. Thermostatic radiator valves should also be installed, to allow the temperature of each room to be controlled to suit individual needs, adding to comfort and reducing heating bills. For example, they can be set to be warmer in the living room and bathroom than in the bedrooms. Ask a competent heating engineer to install thermostatic radiator valves and a fully pumped system with the pump and the boiler turned off by the room thermostat. Thermostatic radiator valves should be fitted to every radiator except one – the radiator in the same room as the room thermostat. Remember the room thermostat is needed as well as the thermostatic radiator valves, to enable the boiler to switch off when no heat is required. It is best to obtain advice from a qualified heating engineer.

3. 3
   Increase loft insulation to 270 mmIndicative cost: £350

   Loft insulation laid in the loft space or between roof rafters to a depth of at least 270 mm will significantly reduce heat loss through the roof; this will improve levels of comfort, reduce energy use and lower fuel bills. Insulation should not be placed below any cold water storage tank; any such tank should also be insulated on its sides and top, and there should be boarding on battens over the insulation to provide safe access between the loft hatch and the cold water tank. The insulation can be installed by professional contractors but also by a capable DIY enthusiast. Loose granules may be used instead of insulation quilt; this form of loft insulation can be blown into place and can be useful where access is difficult. The loft space must have adequate ventilation to prevent dampness; seek advice about this if unsure (particularly if installing insulation between rafters because a vapour control layer and ventilation above the insulation are required). Further information about loft insulation and details of local contractors can be obtained from the National Insulation Association (www.nationalinsulationassociation.org.uk).

Source: the property’s domestic EPC recommendations (open data). Indicative only, get a professional survey before committing to any measure.

Other homes nearby